You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
RadioReference.com Forums
I am looking for some thoughts on Etrunker 3.8.3 and why the program would just stop and display the message "want cts" on the top line. I know what it means ... the program has lost the control channel. But this doesnt appear to be the case.
The problem is as below.
This is after the program has run for a few hours or days and the control channel hasn't changed and the program is still running. (It still responds to key presses etc .... )
I can run the same exact exe on a 486 laptop for as long as I want .. it will never die. But running on a faster pentium laptop it is showing this problem.
I have slowed the processor down in the bios. - No help
Tried different laptops ... same problem.
If the program is started again ... it is fine.
Anyone have any thoughts ... or know of a good program I can use to help diagnose the problem ?
Any help appreciated .. as 486 laptops are somewhat hard to find.