Lost Memory

[jburgermeister]

I've had my BC246T since just before Christmas and think it's an
excellent scanner. Today however I've encountered a problem. I've
been using the Uniden software for programming and had up to 63% of
the capacity used. This morning I added a few more systems to my
configuation and when I tried to reprogram my scanner it now gets to
55% capacity and says that the memory is full. It won't let me add
anymore systems. Obviously that's 18% less tham I had stored
previously. Has anyone else encountered this problem? Any
suggestions on how to regain my lost memory capacity?

-- Joe

 

[Voyager]

I've had my BC246T since just before Christmas and think it's an
excellent scanner. Today however I've encountered a problem. I've
been using the Uniden software for programming and had up to 63% of
the capacity used. This morning I added a few more systems to my
configuation and when I tried to reprogram my scanner it now gets to
55% capacity and says that the memory is full. It won't let me add
anymore systems. Obviously that's 18% less tham I had stored
previously. Has anyone else encountered this problem? Any
suggestions on how to regain my lost memory capacity?

-- Joe

Since you also asked here, I'll post the solution here for others to see:

Check for a group with more than 200 channels or TGs in it. I had a
similar problem and that's what did it. I erased that group (it was only
a test) and everything worked fine again.

Note that this was the solution per the original poster.

Joe M.