makeing sure i got it right

Status
Not open for further replies.

swstow

Member
Feed Provider
Joined
Nov 17, 2006
Messages
329
Location
Erlanger Ky
ok this is my first time programing the indiana safe-t system
im good on digtal,conv,edac but this system sounds different


i entered all the fequencys i need
i entered all the tigs i need
but the question is ( from reading the forum ) i need to set the system to moto type 2 800
and do i set it as a s or p type / im programming a 396t
btw im useing scan control softwere


thanks jim
 

jerk

Active Member
Joined
Sep 5, 2003
Messages
2,449
Location
jerkville
ok this is my first time programing the indiana safe-t system
im good on digtal,conv,edac but this system sounds different

i entered all the fequencys i need
i entered all the tigs i need
but the question is ( from reading the forum ) i need to set the system to moto type 2 800
and do i set it as a s or p type / im programming a 396t
btw im useing scan control softwere

thanks jim
Not sure what S or P means. Just set it as regular 800 Type II system, do not use the splinter option. Also the Uniden programing software is available for free from Uniden and there is BCtools and Freescan which will program much easier and you can import from RR here by paying a small fee.
 
Status
Not open for further replies.
Top