DougTucker
Member
- Joined
- Mar 2, 2020
- Messages
- 6
I'm having trouble programming my MCS2000 for repeaters and could use some assistance. I have successfully programmed specific channels with no PL tones, and can transmit and receive clearly. However, when I try programming PL tones, I cannot hit the repeater, and cannot hear traffic from the repeater. I need some assistance navigating the screens in the software.
Here's some background info:
Software & Hardware:
1. General: Frequency, DPL, codes per repeater owner
2. RX Options: Standard (I tried different settings with same results)
3. TX Options: 3.4 kHz (I tried different settings with same results)
4. Direct/Talkaround [ ] (un-checked)
5. Signaling (None)
6. Secure (no settings)
7. Phone (None)
8. Smart PTT: Disabled
9. Scan (None)
10. VRM (nothing)
11. Advanced: (nothing selected)
Thank you in advance for any assistance you can offer.
~Doug T. WRFL449
Here's some background info:
Software & Hardware:
- MCS2000 Ver. R02.02.00
- USB cable (MCS2000 FTDI USB Serial Cable)
- Windows XP, 32 bit
1. General: Frequency, DPL, codes per repeater owner
2. RX Options: Standard (I tried different settings with same results)
3. TX Options: 3.4 kHz (I tried different settings with same results)
4. Direct/Talkaround [ ] (un-checked)
5. Signaling (None)
6. Secure (no settings)
7. Phone (None)
8. Smart PTT: Disabled
9. Scan (None)
10. VRM (nothing)
11. Advanced: (nothing selected)
Thank you in advance for any assistance you can offer.
~Doug T. WRFL449