n5pwp
Member
Or at least it 'seems' that it stops. I have the HT loaded with the latest firmware (V01.34) and MD380Tools (2017-03-14). When I put it into scan mode sometimes it seems as though its been a while since I've heard a transmission. I'm also monitoring the repeater using DSDPlus and can see transmissions coming from the repeater. If I reach over and tap the red key(exit?) usually I then start receiving. Then it works as expected for a while. I have the squelch set to normal so I don't think its a squelch issue. When it receives it receives beautifully. What does the exit key do when I hit it? It doesn't seem to take it out of scan mode because the LED on the top continues to blink red. Also I can look over and see the LED turn green indicating it is receiving a signal. I suppose it might be just a timing issue but it seems strange that just when I tap the exit button audio pops in.
Thanks.
Mike
Thanks.
Mike