Metro Fed TRS / Pro96com

[datainmotion]

OK - so, I've searched the CO forum to no avail on this:

I have the "Metro Fed TRS" (under Arap Co. page) programmed in my PSR-500 but nothing shows up (0% decode even though I can hear the CC loud and clear) on Pro96com. I thought that maybe I needed to use a custom trunking table (following the Pro96com instructions for this), but that no workee either. Also, when I downloaded the RR info, it shows at MOT VHF/UHF - should I change that to P25 Auto instead?

Added - or is this a 3600 baud system?

What am I doing wrong?

Thanks,

Mike

 

[scanlist]

The Federal 400 system is a 3600 Type II ASTRO smartzone system.

PRO96COM only decodes 9600 P25 Control channels.

Unitrunker is your best bet for logging this system with a PSR-500.

 

[datainmotion]

Thank you.

I ran a Win500 CC dump and see its labeled M36. Off to UniTrunker it is then.

Thanks again!

 

[eyes00only]

The system will work with the PSR 500.

JK

OK - so, I've searched the CO forum to no avail on this:

I have the "Metro Fed TRS" (under Arap Co. page) programmed in my PSR-500 but nothing shows up (0% decode even though I can hear the CC loud and clear) on Pro96com. I thought that maybe I needed to use a custom trunking table (following the Pro96com instructions for this), but that no workee either. Also, when I downloaded the RR info, it shows at MOT VHF/UHF - should I change that to P25 Auto instead?

Added - or is this a 3600 baud system?

What am I doing wrong?

Thanks,

Mike

 

[datainmotion]

Yes - it works fine on the PSR-500. The issue was getting Pro96Com to decode it.

 

[eyes00only]

Yes - it works fine on the PSR-500. The issue was getting Pro96Com to decode it.

Sorry, I just read it wrong. Dang senility!

JK

 

[Warbirdhunter]

Sorry, I just read it wrong. Dang senility!

JK

Hitting the ETOH alittle early huh?? :lol:

 

[eyes00only]

Hitting the ETOH alittle early huh?? :lol:

Actually just now starting my holiday cheer :lol:.

JK