BCD325P2/BCD996P2: [mot2] starcom21 il

[pilottwin]

Scanner previously showed this with a 1 in SO display line and scanned normally. Now this SO position shows a - and scanner shows Nothing to Scan

 

[N9JCQ]

Pilottwin, basic question,d what are you trying to scan?

 

[pilottwin]

Trying to scan Mot Type II P25 system

 

[UPMan]

You've deleted the system or changed its SQK to some other value.

S0 1 - - - - - - - -

means that SQK 01 is enabled.

S0 - - - - - - - - -

means that no SQK 0# is assigned (#=1-9,0).

S0 * - - - - - - - - - - -

would mean that SQK 01 is defined but disabled.

 

[marksmith]

You need to go back into your system and redefine the quick key as 1.
Then start scanning, and you should either get the 1 or the *.

If you get the * then you need to press the 1 key while in scan mode.

Mark
WS1095/536/436/996P2/HP1e/HP2e/996XT/325P2/396XT/PRO668/PSR800/PRO652

 

[pilottwin]

This Site originally was set as quick key 1, but now shows no quick key no. When I select QK 1, I get message By Site and no QK is assigned

 

[teufler]

using Freescan, read the radio, then do a ctrl k in Freescan, then auto select. You shopuld then see the block that was open on 1 have a check in it. Then send this back to the radio.

 

[teufler]

With Freescan, read your radio, then CTRL K, then auto select. You should see one with a check mark. If so send this back to the radio. If you didn't see 1 checked, highlight the system that you want asigned to 1. It is BLUE now. Then on the right, you see find free, 1 should show upo, or you can assign 1 in the quick key block. now ctrl k again, auto select, then send this back to the radio.

 

[scanman1958]

I had the same problem before and Upman helped me. It is tricky to "re-enable" SO 1 if you have turned it off. You may have to ask for a step by step fix to the problem. I think it involves holding a certain button while turning the scanner back on. Not sure, but as I said Upman did help me before. It is posted on RR somewhere.