Motorola astro saber 1 - not scanning ?

[BITT211]

Have a motorola astro saber 1 - uhf - 403-470 mhz , uhf portable
have all the lastest firmware , software updates installed
problem - mixed analog and p-25 apco digital on zone 1 [a] setting.
The astro on scan [will] scan [analog] channels but will not scan [p-25 ] channels
i have 5 - p-25 channels and 4- analog channels on zone 1 [a] setting . I can only listen to 1 channel @ a time , by selecting channel selector 1-2-3-4-5 on p-25. The audio is crystal clear.
Does anyone have any ideas on what to look @ next , internal scan board problem or a program setting that was missed. Thanks for any relpy!

 

[FFPM571]

make sure that the scan list is enabled on the personality

 

[SCPD]

make sure that the scan list is enabled on the personality

I second that. There is a few times I programmed a few lists and forgot to enable it !:banghead:

Sent from my SCH-I605

 

[BITT211]

Astro saber 1 not scanning?

Saw the feedback , thanks , [scan list is not enabled on personality]

would that affect the p-25 section only ? Analog does scan fine , but does not scan p-25 ? Thanks for anymore ideas !!

 

[BigLebowski]

You need to go into each personality (1-16) and assign a scan list to EACH personality, otherwise if you are sitting on that personality the radio will not scan due to not having a scan list assigned to it.

You also need to assign the channels that you want to scan to the said scan list.

I usually do one scan list per zone... The first thing I do is create a new blank Scan list, we will call it Scan List 1. I then create 16 personalities, and assign all 16 to scan list 1. I then go into the zone channel assignment and create 16 channels in the zone, and assign the 16 personalities I created to channels 1 through 16.

After that if it still is not scanning, that would point to your NAC or tone being incorrect and muting the channels, OR you have signaling enabled on the channel and it is set to AND unmute, which will mute all of the traffic.