I recently purchased a CDM1550 off E-Bay. I was able to program the unit and even install the unit in my vehicle. I noted though the TX and RX lights did not seem to work (or maybe it is one in the same based on the CDM 1250 in the engine last night I saw).
Anyway, The backlight works, the Scan light works, the monitor light works...could it simply be the red light does not work?
I contacted the seller and he said was all tested good upon leaving him - he has over 30 years experience...(noted in the response).
He asked if a Motorola shop programmed and installed...so easily the answer is no...but I have been installing my own equipment for quite some time.
Has anyone experienced any issues like this before?
I know I am not experienced Moto installer, but...just wanted to see if it is me or him before I give a lower rating due to his response to my inquiry.
Thanks.
Anyway, The backlight works, the Scan light works, the monitor light works...could it simply be the red light does not work?
I contacted the seller and he said was all tested good upon leaving him - he has over 30 years experience...(noted in the response).
He asked if a Motorola shop programmed and installed...so easily the answer is no...but I have been installing my own equipment for quite some time.
Has anyone experienced any issues like this before?
I know I am not experienced Moto installer, but...just wanted to see if it is me or him before I give a lower rating due to his response to my inquiry.
Thanks.