• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

Motorola R1011B power supply problems

Status
Not open for further replies.

Mogman

Member
Joined
Jun 3, 2014
Messages
25
Location
Skidmore, TX
I have two Motorola R1011B power supplies, one I used for bench work at my place of employment for almost 30 years before it was retired and the other one I picked up along the way, both have the same issue, they will run along fine then just trip off (could be 5 min or 24 hrs) These have the ability to "remotely" (for lack of a better term) trip the breaker, I am sure they are not tripping off due to high current but rather some type of error detected by the control circuits, I have noticed that the output voltage does not seem to be real stable when there is no load and they only trip off under no/low load. I think I read somewhere that these were built by General Dynamics not Motorola, does anyone have a manual or other information about these power supplies, they are BTW quite B.A. up to 40V/40A and quite heavy. Also other than the tripping off issue and the small wavering in output voltage all the controls seem to work as they should..
Thanks
 
Status
Not open for further replies.
Top