I am trying to monitor a number of different radio signals in a tight bandwidth at once. I would like to be able to use one device, like the SDRplay devices that can monitor 10MHz and separate the output into multiple streams around the desired frequencies. Their software allows this but only sends it to a sound card. I need to send it to a pipe to run through dsdcc for streaming. I am also trying to do this on raspberry Pis so I am looking for a headless
command-line based solution.
My best idea is to have master unit runing with the SDRplay running rx_tcp or a sox server and have the slave units pull the data from the master in the proper frequency ranges to run through DSDCC and stream; however I have not found any solution that would allow me to take the IQ data from the network stream to a pipe. Any guidance is greatly appreciated.
command-line based solution.
My best idea is to have master unit runing with the SDRplay running rx_tcp or a sox server and have the slave units pull the data from the master in the proper frequency ranges to run through DSDCC and stream; however I have not found any solution that would allow me to take the IQ data from the network stream to a pipe. Any guidance is greatly appreciated.
Last edited: