Need help, programming cable colours

Status
Not open for further replies.

Babyface

Member
Joined
Aug 16, 2008
Messages
9
Hello everyone,
i've put in a few hours of searching on the forum and the net but i haven't found exactly what i'm looking for. I guess it's time to post for help because maybe i'm not using the right terms in my search.
My serial programming cable for my BC996T has been pulled apart at the scanner end and i need to know which wire colour is welded to which pin. I found only one thread talking about this but it doesn't mention where pin 1 is from right to left and which is the top or bottom of the plug.


-----------------------------------
I I
I --?-- --?-- --?-- --?-- --?-- I
I__--------______---------__I <---- Front of the plug that goes into the face plate of my BC996T


Can someone tell me which wire goes where or if possible show a picture of the wires welded to the back of the plug. A picture is worth a thousand words.

The help would be greatly appreciated. I don't really want to buy a new cable when 10 minutes of elbow grease can fix this one.
 
Last edited:
Status
Not open for further replies.
Top