New Firmware Uniden 996/396

Status
Not open for further replies.

r60

Member
Premium Subscriber
Joined
Dec 22, 2005
Messages
896
Location
Down here now
For those Jersey folks that do not look at the Uniden RR fourm,take a look.

It took me 5 minutes to apply 1.06.00 to my 996xt.

Much better on P25, also fixed squelch level not letting the 700 PSIC
through.

Well done Paul!
 

Highpockets

Member
Joined
Dec 31, 2003
Messages
3,801
Location
New Jersey
For those Jersey folks that do not look at the Uniden RR fourm,take a look.

It took me 5 minutes to apply 1.06.00 to my 996xt.

Much better on P25, also fixed squelch level not letting the 700 PSIC
through.

Well done Paul!
You lost me on the squelch level not letting the PSIC through, I had no problem before the update with PSIC? :confused:
 

datainmotion

Member
Premium Subscriber
Joined
Jan 9, 2001
Messages
2,276
Location
Colorado
Just for clarification - this is for the X-series only. The headline is a bit deceptive...:wink:
 

Skypilot007

Member
Premium Subscriber
Joined
Dec 26, 2005
Messages
2,318
Location
Medford, NJ
I live so close to all the sites that I listen too my error rates are usually below 10 on Burlington county and the NJ PSIC system with the factory settings in my 996XT's. Even the few digital TG's on the state 800 system are very low error rates. Some of the patches on the NJ PSIC have terible audio but thats on their end. When mobile the error rates go up a bit but thats to be expected because of varying signal strength. I'm gona hold off on this firmware, let the feeding frenzy cool off a bit and then maybe try it when I get my shack back in one piece...in the middle of re-modeling the shack.
 

W2SJW

Senior Member
Moderator
Joined
Nov 22, 2001
Messages
3,231
Location
Northwest NJ
I agree on the pass-through issues on PSIC - I think it was indicative to all 700 MHz system previous to the firmware upgrade.

Haven't tried PSIC yet tonight, been monitoring Somerset County all evening...
 
Status
Not open for further replies.
Top