Recently bought a G1 voice pager; so far, I’m excited, it’s very sturdy, not much bigger than a Minitor V, but the digital display and ability to program and scan more than a couple frequencies is awesome.
Had a few programming questions though:
First, what are the MDC settings? What is MDC? I’m usually pretty good with google, but can’t find anything on it.
Second, I was super excited about the voice prompts, but it looks like you can only apply them at the H - Receiving Portfolio level. So where my department has 2-Tone codes for fire and Rescue I wouldn’t be able to have the selector switch on A, but receive separate voice prompts depending on wether a fire or Rescue tone hits?
likewise, I wouldn’t be able to set up a silent scan with mutual aid departments, and cause it to voice prompt “Dept 1 stand by for tone” or “Dept 2 stand by for tone” so that I can monitor what’s happening around me, but not jump out of my skin when the tone goes off and it’s not for my department?
Third, OTA settings? Am I able to flash new programming or firmware to my pager over the air? How does that work?
Had a few programming questions though:
First, what are the MDC settings? What is MDC? I’m usually pretty good with google, but can’t find anything on it.
Second, I was super excited about the voice prompts, but it looks like you can only apply them at the H - Receiving Portfolio level. So where my department has 2-Tone codes for fire and Rescue I wouldn’t be able to have the selector switch on A, but receive separate voice prompts depending on wether a fire or Rescue tone hits?
likewise, I wouldn’t be able to set up a silent scan with mutual aid departments, and cause it to voice prompt “Dept 1 stand by for tone” or “Dept 2 stand by for tone” so that I can monitor what’s happening around me, but not jump out of my skin when the tone goes off and it’s not for my department?
Third, OTA settings? Am I able to flash new programming or firmware to my pager over the air? How does that work?