New NYS P25 system? Orleans County Perhaps?

Status
Not open for further replies.

VE3RADIO

Member
Premium Subscriber
Joined
Jan 16, 2008
Messages
1,247
Location
Planet Earth
Hello from across the lake in the Greater Toronto Area.. specifically Oshawa, I have found a new control channel with a NAC of 469 coming in at about 3 bars (on my tower).. it even comes in on a handheld at 1 bar.. The frequency is 851.9125.

According to the database it could be the Genesee simulcast system as the alternate control channel is on that frequency and no NAC is listed.. I did search Industry Canada for a listing but none was found so I am assuming it is coming from somewhere in either Rochester or Buffalo metropolitan areas.

Any ideas guys? Can any of you hear it? I have setup unitrunker on it and am letting it log.

229 0 (0) 001 (1) Genesee Simulcast Genesee 851.28750 851.46250 851.91250a 852.36250a 852.81250a 853.03750c
 

VE3RADIO

Member
Premium Subscriber
Joined
Jan 16, 2008
Messages
1,247
Location
Planet Earth
It is licensed to Genesee County according to the FCC database.
U figured as much but the real question is can anyone over there confirm what i am hearing? The db has it listed as a altrnate control channel not a primary.. i am trying to figure out where its coming from.
 

Saint

Member
Premium Subscriber
Joined
Dec 19, 2002
Messages
3,355
Location
Fort Erie Ontario Canada
851.9125 MHZ

U figured as much but the real question is can anyone over there confirm what i am hearing? The db has it listed as a altrnate control channel not a primary.. i am trying to figure out where its coming from.
I just set up Unitrunker on 851.9125 and I am receiving the control channel very weak right now but unitrunker is decoding all the information as of right now, I'll let it run for awhile and see what it captures.
Steve
 

madmax14304

Member
Joined
Aug 8, 2004
Messages
21
Saint, were you able to actually get unitrunker to follow calls? I have it setup the same as you have in the screenshots and it is decoding the control channel like yours is. The problem is the second receiver just stays parked. It doesn't try to follow at all.
 

Saint

Member
Premium Subscriber
Joined
Dec 19, 2002
Messages
3,355
Location
Fort Erie Ontario Canada
Follow calls

Saint, were you able to actually get unitrunker to follow calls? I have it setup the same as you have in the screenshots and it is decoding the control channel like yours is. The problem is the second receiver just stays parked. It doesn't try to follow at all.
No I did not have it set up to follow calls, I just let it run to capture the information that I submitted to this thread, and I have not tried to listen to this system after that.
Steve
 
Status
Not open for further replies.
Top