theTastyCat
Member
- Joined
- Oct 6, 2007
- Messages
- 151
Hey all - new TRX-2 today. Installed the software from the card, then went to updating all firmware/libraries/everything else. At one point, the scanner started with "Initializing SD interface, updating firmware...DO NOT POWER OFF", then ever so briefly gives an error message and something about error code 4 before shutting off, powering back on, and doing this over and over. I removed the SD, reformatted to FAT32 on a PC, and put it back - same thing.
*Except*
...what when I plug up the USB I have a 50/50 chance of getting either the above *or* the standard "Error detected" message with Error 3-02 at the bottom.
What on earth? I've tried another SD, another cable, and another PC. I'm stumped. I tried the CPU firmware reinstaller but it requires an actual decent connection. Right now, I've got the standard error message (3-02), but it's reading the SD card as drive E. Any chance I can put something on the card this way that will at least allow the scanner to boot so I can communicate with it through EZScan?
Thanks all!!!
*Except*
...what when I plug up the USB I have a 50/50 chance of getting either the above *or* the standard "Error detected" message with Error 3-02 at the bottom.
What on earth? I've tried another SD, another cable, and another PC. I'm stumped. I tried the CPU firmware reinstaller but it requires an actual decent connection. Right now, I've got the standard error message (3-02), but it's reading the SD card as drive E. Any chance I can put something on the card this way that will at least allow the scanner to boot so I can communicate with it through EZScan?
Thanks all!!!