WS1040: Newbie Learning

Status
Not open for further replies.

wucherer

Member
Joined
Nov 27, 2004
Messages
42
Location
North Bergen, NJ
I’m new to my scanner, Whisler WS1040, and programming with WIN500. I have programmed the trunk frequencies to use, uploaded to the scanner via its USB plug into the scanner itself. After I turn off, and turn back on the scanner the portable scanner display shows, “Nothing enabled’. Being new to this portable scanner, and software am stacked. Confused look and asking next correct event?

Thanks,
Keith
 
Joined
Apr 18, 2009
Messages
6,170
Location
CT
I’m new to my scanner, Whisler WS1040, and programming with WIN500. I have programmed the trunk frequencies to use, uploaded to the scanner via its USB plug into the scanner itself. After I turn off, and turn back on the scanner the portable scanner display shows, “Nothing enabled’
Read some of these ideas:
WS1040 -Nothing Enabled message

When your scanner is scanning does the Number 1 show on the screen or do you just see a black dot? If the Number 1 does not appear then ScanList 1 is not enabled.
 
Status
Not open for further replies.
Top