No Control Channel Decode with DSDPlus Public

[Radioactive_Penguin]

I have FMP parked on a control channel on the Ohio MARCS-IP system. I've got the green peak in the middle of the gray bars. When I ran the CC batch file, I just get a screen

 Sync:+P25p1 NAC:343 TSDU

. I've played with the gain, I've played with the correction, but no dice.

Anyone have any ideas?

 

[mikewazowski]

Are you sure you're on a control channel?

 

[Radioactive_Penguin]

Yeah, If I plug the same frequency into Unitrunker I get the stream of data from the site.

The Frequency I'm using is 853.925 (Control channel for Site 01-70)

 

[slicerwizard]

Sounds about right. DSD+ 1.101 doesn't decode P25 control channels. Notes.txt says CC decoding showed up in version 2.5

 

[Radioactive_Penguin]

2.5 is fastlane, no?

 

[BM82557]

I have FMP parked on a control channel ...

You're using FMP? Have you tried FMP24 and have DSDPlus in 1 receiver mode?

 

[slicerwizard]

2.5 is fastlane, no?

Si.

 

[GTR8000]

You're using FMP? Have you tried FMP24 and have DSDPlus in 1 receiver mode?

OP stated he is using the public release (1.101), which lacks both FMP24 as well as single receiver mode.

 

[Radioactive_Penguin]

I've got the one year subscription to Fastlane now, so I have FMP24. Now that I have the Fastlane release, I'm decoding now. Worth the $10

 

[GTR8000]

WELL worth the donation. Great strides have been made between 1.101 and the current FL release 2.235