No Radio ID's Showing

[TexScan780D]

For some reason my PSR-500 stopped showing the radio Id's on a trunk system, so please post the instructions on how to get the PSR-500 to start showing the Id's.

Thank you.

 

[torontokris]

Make sure its enabled in the menu
PGM - GLOB F3 - scroll down - Radio Id's ON

(just doing that by memory on the go so dont quote me)

 

[TexScan780D]

Make sure its enabled in the menu
PGM - GLOB F3 - scroll down - Radio Id's ON

(just doing that by memory on the go so dont quote me)

I never did see Radio ID's ON in the menu.

 

[kikito]

I never did see Radio ID's ON in the menu.

Press PGM, then FUNC + GLOB (F3). Scroll almost to the bottom, 5th from the bottom: "Show RadioID" should be the one.

 

[TexScan780D]

Press PGM, then FUNC + GLOB (F3). Scroll almost to the bottom, 5th from the bottom: "Show RadioID" should be the one.

Thank you.

 

[RKG]

Be advised that the radio has to see the group call channel grant command on the control channel in order to see radio IDs. If you are scanning and therefore enter a comm in the middle, the radio won't see the ID.

 

[scanningisfun]

Be advised that the radio has to see the group call channel grant command on the control channel in order to see radio IDs. If you are scanning and therefore enter a comm in the middle, the radio won't see the ID.

This only happens on analog systems like EDACS/MOTO Type II Analog I believe.

Edit: Just realized this thread was two years old.....

Jacob