Having a lot of issues trying to get my pro96 working with the NSW GRN. I have had the scanner for a number of years and it worked well before the GRN upgrade. I have only recently decided to tune into the GRN again. I have read the posts that the new system uses the same control channels but different talk groups. I have entered the new talk groups without any luck.
I have also attempted to enter data into the trunk settings / multi table without success.
I have read about 2 or 3 different setting -- offset, low, high, base freq and offset. no luck getting it to work.
I am currently using the Arc96 software which does not seem to allow an offset of 16385 to be entered, it keeps changing to 756. although I can enter it in the multi table.
I have multiple towers entered with just the primary control freq, some with the secondary ones.
I can manually tune to a local tower and just get static and what appears to be alpha codes of a couiple of channels showing on the display.
Does anyone any suggestions or even a file for the Arc96 software I could look at.
any help would be greatly appreciated
Thanks..
Russ
I have also attempted to enter data into the trunk settings / multi table without success.
I have read about 2 or 3 different setting -- offset, low, high, base freq and offset. no luck getting it to work.
I am currently using the Arc96 software which does not seem to allow an offset of 16385 to be entered, it keeps changing to 756. although I can enter it in the multi table.
I have multiple towers entered with just the primary control freq, some with the secondary ones.
I can manually tune to a local tower and just get static and what appears to be alpha codes of a couiple of channels showing on the display.
Does anyone any suggestions or even a file for the Arc96 software I could look at.
any help would be greatly appreciated
Thanks..
Russ