Nx-3820HGk ERROR MESSGE

[Hectomilan]

Hi everyone. I’m stuck reading my school
Bus Radio NX-3820. I want to program the frequency on my personal handheld NX5300. But I keep getting an error messge when reading the nx3820. I am using the official software and official license key.

This is the message.

Error,

The configuration data cannot be read from this transceiver because it was written to this transceiver with invalid System Code and Network Category configurations. To read the configuration data from this transceiver, configure the necessary System Key File for this configuration data and then restart the FPU.

Any help woll
Be appreciated. Thanks.

 

[mmckenna]

Do you have the system keys in your software?

 

[Hectomilan]

It was only one key that I received. I uploaded the key to the LMC and then it authenticated the software. If that’s what you’re asking me. Thanks for the help in advance.

 

[Hectomilan]

I didn’t program the school bus radios. I’m not sure who programmed them. I’m trying to read the radio that’s in my bus.

 

[mmckenna]

I didn’t program the school bus radios. I’m not sure who programmed them. I’m trying to read the radio that’s in my bus.

Sounds like they are set up for trunking.

Without the system key, you will not be able to read the radio. You would need to talk to whoever runs the trunking system. They are the ones who will have the system key.

 

[buddrousa]

You should not be programming your personal radio on a Trunking System.
You should have the System Administrator do it for you if they allow Personal Radios on the System.

 

[Hectomilan]

Ok Gotcha ! Thanks guys for the help. I thought they where using a nexedge digital repeater. Not a trucking system.