RadioReference.com Forums
I'm trying to monitor this system: OnQ Network Trunking System, Multiple Locations, Ontario - Scanner Frequencies with DSD+ Fastlane.
I have all the files downloaded: DSD+ 2.42, FMP24-VC.bat, FMP24-CC.bat etc. I have two SDR's connected and working.
None of the files have been changed except for fmp24-cc.bat which I've only changed the frequency to the control channel.
1. Run FMP24-CC.bat
2. Run cc.bat
3. Run FMP24-vc.bat
4. Run vc.bat
I see the window that shows the site and which talkgroups are active etc. The FMP window for the control channel is showing the signal strength etc but the 2nd FMP window is not tuning to any frequency when a talk group is active. I'm also not seeing any of the small blue windows that show the audio signal. I've followed all the instructions on downloading all the required files.
Although for a P25 system I followed these steps:
I think I'm missing something?
I have all the files downloaded: DSD+ 2.42, FMP24-VC.bat, FMP24-CC.bat etc. I have two SDR's connected and working.
None of the files have been changed except for fmp24-cc.bat which I've only changed the frequency to the control channel.
1. Run FMP24-CC.bat
2. Run cc.bat
3. Run FMP24-vc.bat
4. Run vc.bat
I see the window that shows the site and which talkgroups are active etc. The FMP window for the control channel is showing the signal strength etc but the 2nd FMP window is not tuning to any frequency when a talk group is active. I'm also not seeing any of the small blue windows that show the audio signal. I've followed all the instructions on downloading all the required files.
Although for a P25 system I followed these steps:
I think I'm missing something?