I am trying to trunktrack the OnQue NEXEDGE48 system here (System 202-16) with DSD+. I have DSD+ getting the control channel signal from my tapped Pro97 (cc.bat). It is decoding no problem. I am using DSD+ fmp-vc.bat to to tune the voice frequencies through the use of a RTL-SDR dongle.
When it tunes a voice channel, all I get is noise. I get the same as if I was monitoring that frequency raw from a scanner. I was under the impresssion that DSD+ would decode the data to legible voice to my speakers. Is than an incorrect assumption? I don't think its encrypted ... If not, what have I done wrong?
Also ... after a transmission has been sent to my speakers, I get a noticeable and annoying squelch tail. Is there a way to eliminate that?
When it tunes a voice channel, all I get is noise. I get the same as if I was monitoring that frequency raw from a scanner. I was under the impresssion that DSD+ would decode the data to legible voice to my speakers. Is than an incorrect assumption? I don't think its encrypted ... If not, what have I done wrong?
Also ... after a transmission has been sent to my speakers, I get a noticeable and annoying squelch tail. Is there a way to eliminate that?
Last edited: