OP25 install on Ubuntu 20.04

Status
Not open for further replies.

jhaab

Newbie
Premium Subscriber
Joined
Jan 16, 2018
Messages
11
Location
Bloomington, IL
I have gotten OP25 up and running on several RPI’s in the past. I went to do an install on a PC that is a fresh install of Ubuntu 20.04 and keep running into something that I must be overlooking. The OP25 install went fine and setup my config. When I attempt to run op25.sh, I keep getting Command not found. I made sure the file is executable in properties. Any ideas of what I may be overlooking? I am wondering if it’s permission issues but seems to have the proper permissions.

Thanks!

Jason
 

jhaab

Newbie
Premium Subscriber
Joined
Jan 16, 2018
Messages
11
Location
Bloomington, IL
Boatbod, Thanks for the quick reply. I tried that again and says No such File or Directory. I attached a few screenshots for reference. I am still learning Linux so probably something easy I am overlooking..
 

Attachments

a417

U+0000
Joined
Mar 14, 2004
Messages
3,478
Very simple, you are attempting to change your directory into a shell file - based on that error message.

@boatbod's instructions are two separate lines, you should use the CD ~/op25/op25/gr-op25_repeater/apps command to Change Directory into the apps folder, wait for your command prompt to indicate your new active directory, and then run ./op25.sh
 
Status
Not open for further replies.
Top