What does this function do? I know the default is 11, what happens if I change that number either up or down?
P25 Adjust Mode???
- Thread starter w2csx
- Start date
- Status
rmosier
Member
Hope this helps:
P25 audio decode level adjustment - The RadioReference Wiki
Here in Morris county NJ I've found the best setting to be Manual 7.
P25 audio decode level adjustment - The RadioReference Wiki
Here in Morris county NJ I've found the best setting to be Manual 7.
What do you have your P25 Adjust Level set at? Thanks for your help.
W9NES
Member
If your P25 Adjust mode is to high above 11 the 396XT will not receive.Try below 11 on your setting and your receive should get better.Play with your setting until you are happy with it.After I played with all of the P25 settings I have found the sweet spot and am very happy.
rmosier
Member
I agree with W9NEW. My sweat spot turned out to be Manual 7, but Auto 8 works pretty well also. Just got to play around with it. Each of our systems might be a little different.
Auto 8????
rmosier
Member
Check out the link I posted, It should explain everything.
I have mine set to auto using the default setting of:
P25 Adjust mode of 11
P25 Adjust Level of 50
with the new firmware
With the old firmware I was using a manual setting of:
P25 Adjust Mode of 3
P25 Adjust Level of 200
New new auto setting is working a lot better that the old firmware with the auto setting of 3 and 50.
Mike
- Status