To anyone looking to acquire commercial radio programming software:

Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

To obtain Motorola software see the Sticky in the Motorola forum.

The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

P7100ip : calibration

Thread starter comsec22
Start date May 17, 2024

comsec22

Member

May 17, 2024

I would like to upgrade my two radios from flash J2R11B01 to higher as J2R18K04.. using ProGrammer R20.. isn't allow to go over R11..
If I use RPM even worst.. selecting the new files (radio and DSP) exit to programming mode..
The other issue (maybe due to the firmware version) during programming mode, wishing to align the reference oscillator, radio can't
transmit unless to jump in operational mode. If the new value for the oscillator isn't correct, need to back in programming mode.. really annoy
procedure. To program the radio, I use a modify a vehicular charger, perhaps this can affect tx during programming mode ?
Cheers

You must log in or register to reply here.