When I read my TRX-2 with the Whistler software, I have been getting some sort of value error when it hits a certain system, in this case the system that is labeled as TS008. No matter what I've done (deleting, moving, etc.) I still get an error saying that the "Value must be between 1 and 234678" or something along those lines. In other words, any system that I put in that the program labels as "TS008" prompts the error message. When it does this, it stops reading and the whole program freezes up to the point that I have to use Task Manager to shut it down. When I restart the program, it'll reset all of the of the scanlist names to defaults.
Also, a certain DMR system I monitor has a talkgroup with the ID of 310. When I try to enter 310 into the software, it comes out as gibberish when I add it to the system. The only way I can add it is by entering it directly into the scanner.
Another thing: When I tried to update the firmware, I got an error 4-00 message on the scanner. The only way I've found to clear the error message and get the scanner to work is by disconnecting the power and reconnecting it again.
Also, a certain DMR system I monitor has a talkgroup with the ID of 310. When I try to enter 310 into the software, it comes out as gibberish when I add it to the system. The only way I can add it is by entering it directly into the scanner.
Another thing: When I tried to update the firmware, I got an error 4-00 message on the scanner. The only way I've found to clear the error message and get the scanner to work is by disconnecting the power and reconnecting it again.
Last edited: