dantheman31901
Member
- Joined
- Dec 18, 2012
- Messages
- 40
Hopefully someone could point me in the right direction or clear up some of my errors. I have a GRE PSR-500 programmed with the Rootstown (NEOMED) tower and PC talkgroups. I have a 700mhz Yagi on the roof, LMR-400 cable down to the scanner. The antenna is, to the best of my abilities, pointed towards the Rootstown tower. I am still having trouble getting good, clear audio to pickup.
For those familiar with the PSR-500, I have full bars while scanning the TG's, The T and G icons, for the most part, are always displayed.
Most of the time, the scanner will stop, I'll hear some faint static, and the signal meter falls from full to 1 - 0 bars, no audio. I use Win500 for programming, and at the moment, only have the Rootstown site control frequency programmed. I am located in Atwater, so I'm not terribly far away from the tower but have never had any luck with the included antenna, which is what lead me to going up and outside.
Any suggestions or corrections would be greatly appreciated. I have attached my config file from Win500 for review.
For those familiar with the PSR-500, I have full bars while scanning the TG's, The T and G icons, for the most part, are always displayed.
Most of the time, the scanner will stop, I'll hear some faint static, and the signal meter falls from full to 1 - 0 bars, no audio. I use Win500 for programming, and at the moment, only have the Rootstown site control frequency programmed. I am located in Atwater, so I'm not terribly far away from the tower but have never had any luck with the included antenna, which is what lead me to going up and outside.
Any suggestions or corrections would be greatly appreciated. I have attached my config file from Win500 for review.