I am having trouble getting the Montclair NJ TRS (Montclair Township Public Safety Trunking System, Montclair, New Jersey - Scanner Frequencies) to work in the scanner. It is a Type II SmartNet, Analog/P25 single-site system.
I tried setting the Type to P25 Auto, no luck. I then tried P25 Manual, and entered in the Trunking Table information as follows:
Table 1:
Lo Chan: 0
Hi Chan: 0
Offset: 380
Base: 500.0000
Step: 12.5
Table 2:
Lo Chan: 0
Hi Chan: 0
Offset: 570
Base: 506.0000
Step: 12.5
I am unsure where I can fnd the Lo and Hi channel info, I don't see anything on the page.
I entered all 5 system frequencies. I am picking up the control channel full strength (manually entered all 5 as conventional freqs to test for control channel strength, and found an Analyze feature where it stepped through the frequencies so I can hear if one is the control channel).
Any assistance would be appreciated!
Thanks in advance,
Brian
I tried setting the Type to P25 Auto, no luck. I then tried P25 Manual, and entered in the Trunking Table information as follows:
Table 1:
Lo Chan: 0
Hi Chan: 0
Offset: 380
Base: 500.0000
Step: 12.5
Table 2:
Lo Chan: 0
Hi Chan: 0
Offset: 570
Base: 506.0000
Step: 12.5
I am unsure where I can fnd the Lo and Hi channel info, I don't see anything on the page.
I entered all 5 system frequencies. I am picking up the control channel full strength (manually entered all 5 as conventional freqs to test for control channel strength, and found an Analyze feature where it stepped through the frequencies so I can hear if one is the control channel).
Any assistance would be appreciated!
Thanks in advance,
Brian