moonbounce
Member
- Joined
- Nov 5, 2002
- Messages
- 1,398
Anyone know where you can get parts for one of these? I am looking for the PC-4 board. Googled it but came up empty handed.
Thanks
MB
Thanks
MB
You are better off getting a used one and swapping good parts to the better unit.
Anyone know where you can get parts for one of these? I am looking for the PC-4 board. Googled it but came up empty handed.
Thanks
MB
Hi, Silly Question, I take it that you have tried to reset the CPU ?
Press and hold [CLR]
Press in and release the reset pip switch at the back and the display goes blank
Release [CLR]
Turn off radio, Turn on radio.
Check the 5v regulator for bad connections, especially screw to chassis.
See below for location detail
Realistic Pro-2006 Scanner Refurbishment (unit b) – Mersey Radar
Hope this helps.
try g and g communications in new york state
As soon as one of the buttons are stuck it will disable the whole key section. If that's the problem you cannot do a complete reset as the CLR key doesn't work. Remove the battery and disconnect power and wait till next day to power on.
/Ubbe
When you press that little reset button it resets the CPU but doesn't clear any memory as you'll need the CLR button to work to be able to do that. The disabled keypad gets cleared when you reset the CPU and the scanner probably works as it should, besided that no button works.
When you power on the scanner it senses that a button is stuck, or the connector to it is faulty or something, and it stops working. I.E. there's probably nothing wrong with those ICs or transistor.
I would try and take the keypad apart and clean it and examine the contacts to the main board.
/Ubbe
I have had it apart and did clean the keypad and PC-4. I have cleaned these two before ( used a damp cloth ) also tried WD40.
I still have a new never used OEM keypad for the pro-2005/2006. I also had a new OEM backlight but already used it in my 2005.
PM sent, I would like it please if Moonbounce doesnt need it.