Hi.
Can't find anything on this on the forum, but I'll ask around. I have noticed lately that my Pro-96 will be stopped on a frequency, while decoding APCO25 and will suddenly resume scanning without the transmission finishing. I thought that it was my imagination and that the transmission was finished and the delay was not on. But I went through and made sure all the channels effected had the delay set to on. This occured with DSP firmware verison 1.2 and still does it with DSP 1.3 instaled as well.
The frequencies it occurs on mostly have good signal strength and there is no transmissions near by to bleed through and cause the signal to drop out. Even if it did, there should be the set 2 second delay.
Has anyone else seen this behaviour in their own Pro-96?
It doesn't happen all the time on every channel, just occasionally and on different channels in different banks. Does not seem to happen on analogue channels.
Can't find anything on this on the forum, but I'll ask around. I have noticed lately that my Pro-96 will be stopped on a frequency, while decoding APCO25 and will suddenly resume scanning without the transmission finishing. I thought that it was my imagination and that the transmission was finished and the delay was not on. But I went through and made sure all the channels effected had the delay set to on. This occured with DSP firmware verison 1.2 and still does it with DSP 1.3 instaled as well.
The frequencies it occurs on mostly have good signal strength and there is no transmissions near by to bleed through and cause the signal to drop out. Even if it did, there should be the set 2 second delay.
Has anyone else seen this behaviour in their own Pro-96?
It doesn't happen all the time on every channel, just occasionally and on different channels in different banks. Does not seem to happen on analogue channels.