PRO-99 and Narrowband VHF

Status
Not open for further replies.

BigLebowski

Member
Joined
May 5, 2004
Messages
551
Location
Piedmont NC
I did a quick search in this forum, but I didn't come up with an answer.

I picked up a used PRO-99 for conventional monitoring and frequency sniffing, and so far it seems to be a great radio.

My question is that although I can enter in something like 155.7525, I cannot enter any fed frequencies like 165.2875. The manual seems to indicate that I should be able to enter that frequency, but I can't seem to get the scanner to take it, as it defaults to 165.285.

Any ideas?
 

N8IAA

Member
Joined
Dec 19, 2002
Messages
7,047
Location
Fortunately, GA
I did a quick search in this forum, but I didn't come up with an answer.I picked up a used PRO-99 for conventional monitoring and frequency sniffing, and so far it seems to be a great radio.My question is that although I can enter in something like 155.7525, I cannot enter any fed frequencies like 165.2875. The manual seems to indicate that I should be able to enter that frequency, but I can't seem to get the scanner to take it, as it defaults to 165.285.Any ideas?
Tried putting in a local frequency in that range. It defaults to the 5Khz step. My 163 and 106 will do those steps. Not part of the firmware in the 99.
Larry
 
Status
Not open for further replies.
Top