Set up the pc for the bc396xt first. No problems with unitrunker. Now I've got the Pro106 and have run the driver disk so on and so forth. 2 com ports in Dev Mgr. #'s 3 & 4. Com 3 for the bc and it's serial to usb driver, and com 4 for the pro106 with it's driver. Have messed with port settings and still don't have access to the radio. RS connector cable has a green flashing (actually strobing with the data) led lit up. Was only flashing slow red before installing the 3" adapter. All references on wiki and forums show a 115,200 baud rate while I seem to get the green light with 9600, 8-N-1 and all that jazz. Even though I have seen one reference (wiki or forum, I'm not sure) saying "don't use the 3" adapter. LED activates and deactivates with starting/stopping both programs (unitrunker and Pro96com). Any ideas, or should I start drinking again? : )
p.s. Thx to all for any help.
p.p.s. Have only been trying to set up for single control with the eventual goal of dual radio control.
p.s. Thx to all for any help.
p.p.s. Have only been trying to set up for single control with the eventual goal of dual radio control.