My Pro96 Scanner all of a sudden has been taking a long time to decode the control channel on a local APCO-25 system. According to the Database on this site, the closest tower is less then 5 miles from my house that uses this control channel.
Whenever I turn on the scanner, I have to manually tune to the control channel and wait a few minutes for the signal strength percentage to show up then start scanning. Usually this procedure works fine.
Any ideas what could have happened in the programming or did my scanner just die. This scanner has always been finicky with the new digital system, but this is a new problem within the last 2 weeks.
Any ideas? I found that the v1.3 worked better then v1.4 but is there any work of a newer update coming?
Whenever I turn on the scanner, I have to manually tune to the control channel and wait a few minutes for the signal strength percentage to show up then start scanning. Usually this procedure works fine.
Any ideas what could have happened in the programming or did my scanner just die. This scanner has always been finicky with the new digital system, but this is a new problem within the last 2 weeks.
Any ideas? I found that the v1.3 worked better then v1.4 but is there any work of a newer update coming?