Hey guys, I'm new to all of this so please bear with me on this issue.
Windham NH has two fire frequencies. The first one (154.17500) is for dispatch and the second (452.92500) is for operations. 95% of the time everything works well but 5% of the time the scanner (BCD436HP) stays on the wrong frequency and I just hear is a very low hum.
Example:
154.17500 - Dispatch Tone Out
452.92500 - Units responding
154.17500 - Dispatch immediately begins providing additional information about the call after the units are on responding. I think the scanner is staying on the operations frequency and not switching over back to the dispatch channel.
When this happens there is just a low hum. It's not the same as a transmission that can't be understood. Is there anyway to adjust the sensitivity so it switches over the correct frequency?
Thanks
Windham NH has two fire frequencies. The first one (154.17500) is for dispatch and the second (452.92500) is for operations. 95% of the time everything works well but 5% of the time the scanner (BCD436HP) stays on the wrong frequency and I just hear is a very low hum.
Example:
154.17500 - Dispatch Tone Out
452.92500 - Units responding
154.17500 - Dispatch immediately begins providing additional information about the call after the units are on responding. I think the scanner is staying on the operations frequency and not switching over back to the dispatch channel.
When this happens there is just a low hum. It's not the same as a transmission that can't be understood. Is there anyway to adjust the sensitivity so it switches over the correct frequency?
Thanks