• Effective immediately we will be deleting, without notice, any negative threads or posts that deal with the use of encryption and streaming of scanner audio.

    We've noticed a huge increase in rants and negative posts that revolve around agencies going to encryption due to the broadcasting of scanner audio on the internet. It's now worn out and continues to be the same recycled rants. These rants hijack the threads and derail the conversation. They no longer have a place anywhere on this forum other than in the designated threads in the Rants forum in the Tavern.

    If you violate these guidelines your post will be deleted without notice and an infraction will be issued. We are not against discussion of this issue. You just need to do it in the right place. For example:
    https://forums.radioreference.com/rants/224104-official-thread-live-audio-feeds-scanners-wait-encryption.html

Programming LATIE

Status
Not open for further replies.

SOUTH300

Member
Joined
Jun 13, 2002
Messages
217
Location
Carencro, LA
I hope this does not sound too elementary, but when I enter the 700MHZ frequencies for LATIE into my 996, it only lets me enter 4 numbers after the decimal point. I see in the listings that LATIE uses 5 digits after the decimal point in the frequency. How do I set the scanner to accept the 5 digits?
 

loumaag

Silent Key - Aug 2014
Joined
Oct 20, 2002
Messages
12,911
Location
Katy, TX
Stormchaser_35 said:
How Much does that affect reception, i am guessing not
None at all. You are talking about a resolution of 50 Hz either way, which even with the super narrow band allocation (6.25 KHz) is nothing.

Look at it actual Hertz numbers:
Actual LATIE Frequency: 774031250 Hz
Uniden 396/996 resolution: 774031200 Hz
(on this you only see to the hundred Hz level or 7740312 Hundred Hz)
 

loumaag

Silent Key - Aug 2014
Joined
Oct 20, 2002
Messages
12,911
Location
Katy, TX
bigjosh70363 said:
anybody know the exact freq on the latie system for terrebonne SO????????
Wouldn't that be the Gray tower (Site 116) on the LATIE System? Your question leads me to believe that you may not understand how a Trunking System works, if that is the case read Trunking Basics in our Wiki.

BTW, Welcome to the forums after being a member for so long. :)
 
Status
Not open for further replies.
Top