whitesox4life
Member
I am needing to program a local IIi system into my scanner but dont know the fleet map. do i need to know this BEFORE programming?
This step in programming fleet maps refers:whitesox4life said:I am needing to program a local IIi system into my scanner but dont know the fleet map. do i need to know this BEFORE programming?
whitesox4life said:I am needing to program a local IIi system into my scanner but dont know the fleet map. do i need to know this BEFORE programming?
Dave's example is in this jpg. Also note the frequencies listed in bank 1 are for site 1 (bank 2 has site 2 but all ID's are in both banks). Insure the check is in the box under Trunk for each trunked frequency and FM is selected under Mode. Leave unchecked under Trunk any conventional freqs listed after the trunked freqs, however, check the correct mode for conventional freqs.DaveIN said:One thing to try, make sure you are using the decimal talkgroups and not the hex.
Because the scanner can only have one active control per bank, each site must be in seperate banks, but you can use the same talkgroups in each bank.edmundl118 said:I can load all the freqs in the same bank? right or I would have to keep them in two different ones (2 banks)
Some scanners use or can be set to find the voice frequencies via the CC. The 94 requires that all freqs be entered. And each site must be programmed in separate banks. You can however, program all or any part of the ID's in each bank.It has a spot for Moto CTRL chan plan, any idea what that would be for?
Fleet maps are for Motorola Type I or IIi (hybrid) systems. Bethlehem is Type II and the setting on the right of my example (Mot Type II 800) is all that is needed. This actually sets all 8 blocks in the Fleet map to size code 0, which is actually the Type II setting.Any idea bout the Fleet map settings? or where I could get the information from?
This from your previous:"D-err No. 054 End"
The ID number 145 is incorrect (should be 144) and possibly ID 1008 is what should be in place of 978, also incorrect. The rule is each of these ID's should be divisible by 16 to a whole number. I think the first ID (145) may be causing the rejection of all in the transfer.Freq group mode Group ID
852.13750 Bethlehem FM List1 - 1 145
852.58750 Bethlehem FM List1 - 2 976
854.66250 Bethlehem FM List1 - 3 978
854.96250 Bethlehem FM List1 - 4 1040
854.98750 Bethlehem FM List1 - 5 1104
855.96250 Bethlehem FM List1 - 6 1168