ion_op
Member
Hi,
I programmed the primary control channels into the 160 but when I hit scan it just scans through the channels. One I hear control data but MOT does not display. I see that there's a custom frequency table but this part always confuses me. I'm suspecting that I need to do this as well but what is the range?
Tnx,
Mike
I programmed the primary control channels into the 160 but when I hit scan it just scans through the channels. One I hear control data but MOT does not display. I see that there's a custom frequency table but this part always confuses me. I'm suspecting that I need to do this as well but what is the range?
Tnx,
Mike