PSR-100 Computer upload

Status
Not open for further replies.

fredg

Member
Premium Subscriber
Joined
Dec 23, 2007
Messages
105
Location
East Central Kansas
I think there is only one other person posting here that owns a PSR-100 but I figure I will ask... is it possible and how do you upload to the PSR-100 from a computer? I did the clone thing with my PSR-200 when I had it but I can't figure out how to upload from a computer.

I think the PSR-100 is an upgrade to to RS Pro-82 which CAN upload from a computer so surely the PSR-100 can.....

How about any keypad "hacks"?

I have an support incident in with GRE asking about the computer upload....
 

fredg

Member
Premium Subscriber
Joined
Dec 23, 2007
Messages
105
Location
East Central Kansas
Got some info back from GRE:

After the PC clone cable is plugged in, PSR-100 is ready to accept the data. When cloned with PC, no key is needed to be pressed. The PSR-100 is different from the Pro-82 in this regard.

I'm not aware of any third party software at this time, but yes, it is possible to upload and download to a computer. I'll check on your serial data questions.
I asked about protocol info such as baud rate, stop bits etc. and a possible list of commands that can be used from a program like HyperTerminal. With this info it should not be hard to write some simple software to upload and download data.
 

fredg

Member
Premium Subscriber
Joined
Dec 23, 2007
Messages
105
Location
East Central Kansas
Final word from GRE tech support:

The PSR-100 communications at 4800, N, 8, 1.

Unfortunately I can't give you any more detail than that at this time. There is a detailed specifications document available to bona fide developers who are willing to sign an NDA. I can point you towards the person responsible for that if you'd like.
Bummer...
 
Status
Not open for further replies.
Top