Since the PSR 500 is able to be programmed with several priority channels, is there a setting that allows the user to set a hierarchy to the list, thus allowing priorities within the priority list, similar to my (very old) BC200XLT?
PSR 500 Priority Channel Settings
- Thread starter emscapt9816
- Start date
- Status
DonS
Member
No.
While scanning, the PSR-500/600:
a. at the defined <GLOB "Pri Interval">, check up to <GLOB "Pri Channels"> CONV objects flagged for priority
b. at the beginning of each pass on each trunking system, wait a short time for any priority-flagged TGRPs in that TSYS to go active
There's no other priority "hierarchy".
While scanning, the PSR-500/600:
a. at the defined <GLOB "Pri Interval">, check up to <GLOB "Pri Channels"> CONV objects flagged for priority
b. at the beginning of each pass on each trunking system, wait a short time for any priority-flagged TGRPs in that TSYS to go active
There's no other priority "hierarchy".
It was worth a try...
Thanks Don. I hoped I was missing something. I can't complain, though. This radio does so much already.
Thanks Don. I hoped I was missing something. I can't complain, though. This radio does so much already.
- Status