PSR 800 Imprting multiple conventional channels into a scanlist?

[tampatracker]

I've got the channels I want imported into the conventional systems page, I just can't figure out how to move them into the target scanlist. Excuse me if this has been asked before, I couldn't find it with a search.

 

[Halfpint]

Hmmmmm... Since I admit that I don't actually have the scanner but rather just the program you might take this with the proverbial `grain of salt'.

Go to the `Conventional Frequencies' tab and look down at the very bottom of the window that has all the freqs entered. There you will most likely see a `scroll bar' w/ the `tab' all the way over to the left. Go over to the right side of the `scroll bar' and click on the left facing arrow on the end of the `scroll bar'. That should then bring up the `Scanlists' header at the top of the window. Click on the line for the freq you want to put into the scanlist you desire and you should end up with a window listing all your scanlists. Choose the ones you want *and* do not forget to remove any others that may have be applied via the `default scanlist' setting if you do not want them.

 

[ChargerSRT8]

Halfpint is correct, and you can choose multiple lines, but you must choose them using the rec# column, highlighting them using Windows editing conventions.

 

[tampatracker]

Thanks guys, this scanner has a pretty steep learning curve, but it sure is fun climbing it!