Happy New Years!!!! Group
Quick question in regards to QC tone outs. Have a dedicated channel on XPR-3500 for local FD page. QC tones are set correctly and the radio is set to receive only. When a call is toned out I have the setting set as follows: UNDER Signaling Systems - QC II Sys1
1) call type- Call Alert w/ voice
2)call format- A-B/C-D
3)All tones populated
4) Auto Reset Timer Type: Auto w/ Carrier Override
5) Side Tone: Short
6) Pretime: 500
7)Long Tone: 3
8 ) Limited Patience Timer: 60
When a call is received it opens up the audio the dispatcher transmits the message. Then the radio continues to beep until I manually press any side button or the PTT.
What am I doing wrong? I would like the message to broadcast, but clear and audio go back into “Alert” mode instead of the beep continuing. All help would be appreciated. I also am including the MDC Sys1 settings as well, perhaps this might be the issue. I don’t know.
Quick question in regards to QC tone outs. Have a dedicated channel on XPR-3500 for local FD page. QC tones are set correctly and the radio is set to receive only. When a call is toned out I have the setting set as follows: UNDER Signaling Systems - QC II Sys1
1) call type- Call Alert w/ voice
2)call format- A-B/C-D
3)All tones populated
4) Auto Reset Timer Type: Auto w/ Carrier Override
5) Side Tone: Short
6) Pretime: 500
7)Long Tone: 3
8 ) Limited Patience Timer: 60
When a call is received it opens up the audio the dispatcher transmits the message. Then the radio continues to beep until I manually press any side button or the PTT.
What am I doing wrong? I would like the message to broadcast, but clear and audio go back into “Alert” mode instead of the beep continuing. All help would be appreciated. I also am including the MDC Sys1 settings as well, perhaps this might be the issue. I don’t know.
Attachments
Last edited: