radiobuff0978
Member
I purchased a Pro 2052 at a flea market that had no power cord. From the specs, it requires 12V DC 500ma. I have a multi adapter I can set to 12 V DC, it puts out 2100ma, which should be fine.
I also tried to get the case off, removing the 6 screws, but it is not easy to get it off. I want to look at the inside an make sure there are no obvious loose wires, etc.
It seems like it is glued together. Is there a trick, to getting the cover off?
Does anyone have a link to a service manual for this scanner Pro 2052?
I also need to know if there is any good programming software for this unit? I have used CHIRP, to program UHF / VHF hand held radios...
Thanks!
I also tried to get the case off, removing the 6 screws, but it is not easy to get it off. I want to look at the inside an make sure there are no obvious loose wires, etc.
It seems like it is glued together. Is there a trick, to getting the cover off?
Does anyone have a link to a service manual for this scanner Pro 2052?
I also need to know if there is any good programming software for this unit? I have used CHIRP, to program UHF / VHF hand held radios...
Thanks!