I have purchased a few used CDM750's over the last 6 months for small projects. I run into the same problem on Low Power models as well as High power models.
I'm not getting the correct RF power when I test the power out on a meter, I have tried a few different meters and antennas.
Using a High power UHF CDM750 as an example AAM25RKC9AA1AN (see attached screenshots):
Radio Information - TX Power - Low=20 Hi=40
Radio Configuration - TX Power - Low=20 Hi=40
Conv Pers 1 - Options - TX Power Level=High
I only get about 25 watts out.
What am I missing here?
I'm not getting the correct RF power when I test the power out on a meter, I have tried a few different meters and antennas.
Using a High power UHF CDM750 as an example AAM25RKC9AA1AN (see attached screenshots):
Radio Information - TX Power - Low=20 Hi=40
Radio Configuration - TX Power - Low=20 Hi=40
Conv Pers 1 - Options - TX Power Level=High
I only get about 25 watts out.
What am I missing here?