Sacramento Fire department

[MatthewBarnes1988]

Does anyone know if the ID codes on here for Sacramento Fire department are up to date because I am picking up no traffic from them?

 

[kma371]

Does anyone know if the ID codes on here for Sacramento Fire department are up to date because I am picking up no traffic from them?

Can you explain what you mean by "ID codes?"

 

[MatthewBarnes1988]

I am talking about the Dec or hex codes

 

[kma371]

I am talking about the Dec or hex codes

Yes those are up to date. Are you sure you have the correct system frequencies programmed?

 

[MatthewBarnes1988]

Yes I know I do because I am picking up sac pd just not getting the fire department

 

[Sac916]

Are you monitoring Site 1, Site 2 or both?

If you want to monitor Sac City Fire Dept, you should be monitoring Site 1 to hear all of the traffic. Site 1 does not have the same coverage area as Site 2


The Talk Group ID (DEC) for Both FIre A and Fire B are accurate.
Sacramento Regional Radio Communications System (SRRCS) Trunking System, Various, California - Scanner Frequencies

 

[MatthewBarnes1988]

I am monitoring both site 1 and 2 and still only getting sac pd not the fire department.

 

[Sac916]

You should be hearing them if you're hearing SPD. Most traffic is on Fire B and B2 - Sounds like a programming issue.

Sent from my Android via Tapatalk app

 

[gmclam]

SRRCS

I am running multiple scanners; one on site 1 and one on site 2; and picking up all Fire TGs as shown in the DB. It's not obvious from the DB, but was stated here in this thread that the B groups are typically used by the city and are on site 1 whereas the A groups are typically used by the county (Sac Metro) and are on site 2.

Start by working in receiving the dispatch TGs; A1 & B1. They are also 'repeated' on VHF. Once you have those, getting the associated TGs should be a small issue.

 

[kma371]

What scanner are you using?

 

[MatthewBarnes1988]

Thanks for all the replys it must have been a problem when I programed it I reprogramed them yesterday and its working just fine now that's again everyone

 

[MatthewBarnes1988]

I am using the uniden bcd396xt

 

[Sac916]

Thanks for all the replies it must have been a problem when I programmed it I reprogrammed them yesterday and its working just fine now that's again everyone

- Glad you got it all sorted out -