I must have inadvertently changed a setting somewhere, because this never used to be an issue until now.
I never used to use Scan Sets much, just Scan Lists. I just enabled whichever Scan Lists I wanted to monitor, and that was it. Now, no matter which Scan List I enable, I get the "Nothing to Scan" message. The only way I can scan anything is to enable at least one Scan Set. But, in this case, it scans everything in that set, regardless of what Scan Lists I have enabled, even if they are all turned off.
I'm sure this must be just a setting somewhere, but I can't figure it out. This is the TRX-1, BTW.
I never used to use Scan Sets much, just Scan Lists. I just enabled whichever Scan Lists I wanted to monitor, and that was it. Now, no matter which Scan List I enable, I get the "Nothing to Scan" message. The only way I can scan anything is to enable at least one Scan Set. But, in this case, it scans everything in that set, regardless of what Scan Lists I have enabled, even if they are all turned off.
I'm sure this must be just a setting somewhere, but I can't figure it out. This is the TRX-1, BTW.