I'm still new to the PSR800, and learning things as time goes by. Something I realized today is when you make changes to your scanlists in the Ezscan software, when you move them around. The changes do not reflect in the scanset list.
So if you go to the General Tab and move a scanlist to another space/number slot, and it already was part of the scanset list, the link to it will now be broken in the scanset list.
This led to problems for me in the past when I thought the scanner wasn't picking something up anymore. So I just thought I would make a note of it here. Any time you make changes in the scanlists on the general tab when something gets moved to a different number, always check your scansets and make sure their numbers match up since they don't change as you make changes on the scanlist page.
So if you go to the General Tab and move a scanlist to another space/number slot, and it already was part of the scanset list, the link to it will now be broken in the scanset list.
This led to problems for me in the past when I thought the scanner wasn't picking something up anymore. So I just thought I would make a note of it here. Any time you make changes in the scanlists on the general tab when something gets moved to a different number, always check your scansets and make sure their numbers match up since they don't change as you make changes on the scanlist page.
