• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

Scanning on Icom IC-/F100F110

Status
Not open for further replies.
S

SonicN

Member
Joined
Aug 12, 2007
Messages
130
I have the programingsoftware, and have programmed the radio as I want it to be. But I can't seem to figure out how to make the radio go into scan-mode.

It is possible, acording to the software, but I can't make it happend.

Point me in the right direction, anyone ?

Typingerror in the topic here.. it is the 110/121-type of radio.

And, does anyone know if it is posible to program it so the speaker becomes activ when recieving a CCIR-code ?
 
Last edited:
A

aaknitt

Member
Feed Provider
Joined
Aug 27, 2005
Messages
1,302
For scanning, you need to program one of the buttons to enable scanning. Also check in the "Common - Key & Display" menu to see if you have Mic Hook scan enabled. This is under "Hanger Action. If this is enabled, the microphone hanger needs to be grounded in order for the radio to scan.

Andy
 
S

SonicN

Member
Joined
Aug 12, 2007
Messages
130
I have tried to ground it, and made the hangeraction to scan, but no luck so far
 
Status
Not open for further replies.

Similar threads

G
Icom IC-F5061/62 - locked on TX after writing codeplug from "identical" radio :(
Replies
2
Views
351
g8tzl2004
G
K
Icom: Icom IC-9700 height with stand
Replies
2
Views
280
K1MLG
K
Stretchman
IC-F9521T issue with analog
Replies
11
Views
815
Stretchman
Stretchman
G
Icom F5061/62 - what are internal pads K and L used for?
Replies
9
Views
1K
g8tzl2004
G
F
Icom IC-2B3
Replies
5
Views
635
jeepsandradios
jeepsandradios
Top