SD TRS Scanning Issue

Status
Not open for further replies.

Elpablo

Member
Joined
Feb 26, 2003
Messages
86
Location
San Diego
Hi all,
Has anyone else had a problem recently when monitoring the SD TRS system where, after a transmission on a talkgroup, it sounds like the frequency stays open and the audio for another talkgroup is transmitted on the open talkgroup that the scanner is stuck on? It could be a squelch problem where the scanner doesn’t recognize the transmission has ended and does not continue to scanning. It stays on the frequency and whatever traffic the controller sends to that frequency next, it transmits no matter which talkgroup it is. I noticed this about a week ago on my BC250D and thought it could be the radio going after some many years but then I noticed the same thing happen on my mobile 796D. Did they do a system update or is there a disconnect tone at the end of transmissions I am ignoring? I have not have this problem when monitoring the RCS. Any help is greatly appreciated!
EP
 

W6KRU

Member
Premium Subscriber
Joined
Nov 20, 2008
Messages
3,438
Location
Oceanside, CA
You need to turn on the End code. This happens when a repeater hangs. We had that happen in the north zone a few months ago. There were a few people who didn't have the End code set and they had the exact same issues that you do.
 

Elpablo

Member
Joined
Feb 26, 2003
Messages
86
Location
San Diego
DDan,

Thanks. That seems to have worked. I had it set to detect on the RCS but not the TRS. I set to detect on the TRS and the issue appears to be resolved.

Thanks, Paul
 

Elpablo

Member
Joined
Feb 26, 2003
Messages
86
Location
San Diego
DDan,

Thanks. That seems to have worked. I had it set to detect on the RCS but not the TRS. I set to detect on the TRS and the issue appears to be resolved.

Thanks, Paul
 
Status
Not open for further replies.
Top