SDS 200 Programming - Please Help

JohnDistai

Member
Premium Subscriber
Joined
Sep 10, 2010
Messages
72
This request is for help with learning how to program the Tac and Ops talk groups that I hear on a 996XT with the SDS 200.

Both scanners are programmed with Wake County, NC systems to listen to Police, EMS, Fire, etc. The programming is downloaded from Radio Reference and installed through ProScan. Again, I hear the Tac talk groups on the 996XT, but I do not hear them on the SDS 200.

What would I need to do to receive these talk groups on the SDS 200? How do I program them?

Thanks!
 

Reconrider

Trx-1 or Sds100
Feed Provider
Joined
Sep 26, 2017
Messages
517
Location
Between the lines
Open sentinel and click the profile button. Click the "services" tab and make sure they're all on.
Here's a picture if you're new to sentinel or just can't find it Screenshot
 

TailGator911

KF4ANC
Premium Subscriber
Joined
Feb 12, 2005
Messages
2,359
Location
Fairborn, OH
Check and recheck all of your programming particulars - location, service types, Downloads and Monitors checked, etc. I have not actually programmed my SDS scanners with ProScan, using it for virtual control, etc., as I use Sentinel. If you have the system in there and it ain't happening, then it's always something that should have been enabled and is not. Something really small and annoying, always. Never fails.
 

phask

Member
Premium Subscriber
Joined
Dec 19, 2002
Messages
3,303
Location
KZZV - SE Ohio
You could also download from the 996 (or load it if you already have it saved) and import it into a 200 database.
 
Top